Then press the "M" button followed by a number button (1, 2, 3, or 4) to assign the current height.Once the memory buttons are programmed, just tap a numbered button and your desk will automatically.How to lock your keypad to prevent accidental adjustments: If you would rather require a press-and-hold of the button, instead of a Press and hold the "M" button until the display shows "LOC.".To unlock your keypad, press and hold the "M" button until your display shows the current numeric.How to toggle between one-touch (single-touch) and constant-touch (press-and-hold) modes: Note: In the event of a power outage, the desk will automatically return to the unlocked setting. Press and hold the "down" button until the desk reaches its lowest position.Press and hold the "down" button once again until the display flashes "RST.".Press and hold the "1" button until the display shows "10.1" (one-touch) or "10.2" (constant-touch)Īnd then goes back to "RST." While the display is flashing "RST," push the "1" button to toggle.Then, press and hold the "down" button until the desktop lowers slightly, rises slightly, and theĭisplay changes back to the numeric height setting.How to switch between inches and centimeters on your display: Press and hold the "2" button until the display shows "10.3" (centimeters) or "10.4" (inches) and.How to calibrate the height display on your desk: Then goes back to "RST." While the display is flashing "RST", push the "2" button to toggle between OFFICE DEPOT STANDING DESK CONVERTER HOW TO Use a tape measure to check the height from the floor to the top side Once the frame is assembled and plugged into a 120V outlet, press and hold the "down" button until theĭesk reaches its lowest position. If the displayed height doesn't match the desk's actual height, follow these steps: If your measurement matches your display, your desk is ready for use. Press and hold the "down" button until the display flashes "RST" then push the "M" button until the.Press the "up" or "down" button to adjust the displayed height to match your desk's measured height.Once the display changes back to "RST," press the "down" button until the desktop lowers slightly.Rises slightly, and the display changes back to the numeric height setting. *Note: "RST" will look like "ASr" on the display. OFFICE DEPOT STANDING DESK CONVERTER HOW TO.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |